Hunter 81003 Manual do Utilizador descarregar pdf (Página 8)

EXISTING FAN

B11

B12

Existing Construction

B13

B14

Route wires through the strain relief. For supply connection,

use wires suitable for at least 90º C (194º F).

Remove an existing fan and check to make sure the open-

ing is large enough to accommodate the new motor hous-

ing (7 1/4”x 7 3/4”).

Move the housing into position above the ceiling.

Attach existing ducting to duct connector. Tape joints.

If ducting does not fit securely,

an adapter may need to be purchased.

B15

Install the housing flush with the sheetrock and secure by

tightening the pre-loaded screws into the joist.

41939-01 1/11/2006

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Sem comentários

Hunter 81003 Manual do Utilizador Página 8